The Northpoint Series is the ultimate in freestanding greenhouses. The Northpoint was developed as one of the original Rimol Greenhouses, designed for multi-functional use as both a growing and retail house. The Northpoint has exceptional versatility, and can also withstand harsh snow and wind loads seen in all areas of the country. For any customization not shown here, please contact a Rimol Sales Associate.
- Available in 22 ft. and 26 ft. widths
- 4 ft. bow spacing standard
- Available in 6 ft. bow spacing
- Bows are 1.66 in., 14 ga. galvanized steel tubing
- Truss assembly with every bow, resulting in unmatched strength
- 3 purlins for the 22 ft. and 26 ft. greenhouse
- Purlins connect to the bows using a cross connector system which prevents unnecessary drilling into the bow
- Truss supports allow for additional purlin pipe to be hung for hanging baskets
- Wind bracing kits included with all greenhouses
- Can be raised with the extended ground posts option
- Engineering meets International Building Codes (IBC)
The frame includes all of the steel tubing pre-drilled, all hardware and ground post driver. Does not include baseboard or end wall framing materials.
Extended Ground Posts
- Standard frame comes with 3' ground posts (2' in the ground, 1' out), causing the curvature of the structure to start around 4'.
- Extended Ground Posts are 6' long (3' in the ground, 3' out), causing the curvature of the structure to start around 6'. This option adds increased working space along the side walls, increased ventilation when coupled with roll-up sides, and depending on your region, may be necessary for NRCS compliance.
End Wall Framing
- 2" x 4" Framing Brackets - includes enough brackets and hardware to frame end walls with 2" x 4" wood. Wood not included.
- Metal End Wall Framing Kit - includes enough 1.5" square steel, brackets, hardware to frame end walls with 1.5" square steel.
End Wall Covering
- Woven Poly End Walls - include woven poly panels for a single layer on each end wall and wire lock to fasten poly to end walls.
- Polycarbonate End Walls - include twin wall clear polycarbonate, all extrusions, hardware and gable wire lock.
- Single Poly - includes one layer of poly, and wirelock to attach.
- Double Inflated Poly - includes two layers of poly, wire lock for along the sides and an inflation kit.
- T-handle - includes roll pipe, hardware and T-handle operators for 2 roll-up sides.
- Manual Gear Box - includes roll pipe, hardware and Manual Gear Box operators for 2 roll-up sides.
- Automated - includes environmental controller, roll pipe, hardware, and Low-Voltage Motors for 2 roll-up sides.
Mechanical ventilation includes an exhaust fan(s), shutters and necessary thermostats to control all equipment.
The gas heat option includes a Reznor high efficiency heater, a heater hanger, a vent pipe kit, and all necessary thermostats to control the equipment.
- HAF Fans: Adds Horizontal Airflow Fans (HAF) with hangars.
- HAF Fans and Variable Speed Controller: Adds HAF Fans with hangars and a Variable Speed Controller to adjust the speed of HAF fans.
You can can select a combination of Single Sliding (42" x 7'), Double Sliding (8' x 8'), and Roll-Up Garage (8' x 8') doors.